This PrimaLuceLab heater prevents condensation from forming on the optics by heating the tube near them.
CHF 62.28
Reference CHAUF-0004
Will be ordered for you—Delivery time may vary depending on whether it is combined with other orders
Will be ordered for you—Delivery time may vary depending on whether it is combined with other orders
This PrimaLuceLab heater prevents condensation from forming on the optics by heating the tube near them.
The 60-mm version fits tubes with diameters ranging from 50 to 70 mm. The Velcro fastener and elastic band allow the strap to be secured around the tube. The diameter range should be verified at the actual point where the strap wraps around the tube, rather than being determined solely by the optical aperture.
The manufacturer specifies power supply and control via an EAGLE, as well as connection to an external 12-volt power source equipped with an RCA connector. The EAGLE is therefore an optional control device, not an accessory listed as included.
This type of equipment is particularly effective at addressing the problem of fogging that occurs on eyepieces and Schmidt-Cassegrain telescopes. Be sure to include the power consumption of this model in the system’s power balance.
| Reference | PLLFAS60 |
|---|---|
| Nominal size | 60 mm |
| Pipe diameters | 50 to 70 mm |
| Power supply | 12 V |
| Connector | RCA |
| Estimated Fuel Consumption | 500 mA |
| Maintenance | Velcro and elastic band |
PrimaLuceLab Official Fact Sheet
Secure the strap around the tube using its Velcro fastener, then connect its RCA connector to a suitable 12-volt power source. With a compatible EAGLE unit and the ECCO2 module along with its probes, the heater’s power can be automatically regulated based on the dew point. These control devices are separate from the heater and are not included.
